Replacement Part List

STEP 1.
Lay cart bed upside down to install axle holder plates. •
Add four axle holder plates to undercarriage plate, as shown, with eight 3/8" x 3/4" hex bolts, •
and 3/8" lock nuts. NOTE: DO NOT TIGHTEN AT THIS TIME.
Loosely bolt together the axle holder plates with eight 3/8" x 3/4" hex bolts and 3/8" lock nuts. •
BED ASSEMBLY
AXLE HOLDER
PLATE
3/8" X 3/4" HEX HEAD BOLT
3/8" LOCK NUT
11
1/2" X 2-3/4" HEX BOLT
1/2" LOCK WASHER
1/2" HEX NUT
FRONT SUPPORT
STEP 2.
Place front support assembly onto front of cart, as shown. •
Insert two 1/2" x 2 1/2" hex bolts through front support angle holes, and holes in •
cart bed tube.
Secure in place with two 1/2" flat washers, two 1/2" lock washers, and two 1/2" •
hex nuts.
1/2" FLAT WASHER
HAIR PIN
FRONT SUPPORT
PIN
AXLE
COTTER PIN
SPACER
HITCH
STEP 3.
Slide axle through axle holder plates, add spacer, drawbar, add another spacer then •
through other set of axle plates.
Center axle and add another spacer, axle washer, tire, axle washer, in that order to •
each side and secure in place by adding cotter pin in axle and spreading ends.
Insert drawbar pin through front support assembly and drawbar, lock in place with •
hair pin.
At this time, tighten ALL bolts. •
NOTE: TIGHTEN ALL BOLTS.
ATV TIRE
SPACER
18
4
6 7 17
8
20
TOOLS REQUIRED
3/4" WRENCH AND SOCKET
9/16" WRENCH AND SOCKET
PLIERS
SAFETY INSTRUCTION
DO NOT CARRY PASSENGERS IN CART.
DO NOT TOW CART ON PUBLIC ROADS.
NEVER EXCEED LOAD CAPACITY - 1000LBS.
AVOID SUDDEN TURNS OR MANEUVERS.
WHEN OPERATING ON SLOPES, USE LOWEST
GROUND SPEED AND LIMIT LOAD TO 200LBS.
OPERATE UP AND DOWN SLOPES, NEVER
ACROSS THE FACE.
MAINTENANCE
CHECK TIRE PRESSURE REGULARLY
(5 PSI RECOMMENDED.)
GREASE WHEELS AT AXLE FOR LONGER LIFE.
PERIODICALLY CHECK ALL BOLTS.
KEEP CART CLEAN TO PREVENT RUST.
STORE INSIDE A CLEAN DRY AREA.
1
3
9
NOTE: DO NOT TIGHTEN
BOLTS AT THIS TIME. THEY
WILL BE TIGHTENED AFTER
AXLE AND WHEELS HAVE
BEEN INSTALLED IN A
LATER STEP.