User's Manual

B526A Manual
Address : #181 GONG DAN-DONG, GUMI, GYEONG BUK, KOREA Page 7/ 9
TEL : [phone] / FAX : [phone]
http://www.ohsungec.com/
Note: if any key is pressed within the timeout duration, the remote stops transmitting the
voice data and activate the pressed key event.
3.7 - Voice Search initiated by the launcher
a) For Voice function, it is recommended to be within 5 meters from the receiver.
b) Distance between mouth and microphone should be within 40 cm (15~20cm
recommended)
c) User selects and validates the voice search on the launcher by using navigation and OK
keys.
d) STB sends the voice search START command to the remote.
e) After timeout duration, the remote stops transmitting the voice data and the LED is
turned off.
f) Or When the remote receive the stop command from STB, thre remote stops
transmitting the voice data and the LED is turned off.
Note: if any key is pressed within the timeout duration, the remote stops transmitting the
voice data and activate the pressed key event.
3.8 – Setup for TV & Audio
a) As long as the RCU is paired to the STB, the RCU can then automatically be set up by
the STB for TV or Audio control.
b) The STB can set the RCU’s IR using the command defined in Appendix1.
c) When the setting is completed, the Volume key and the Power key output the IR signal
according to the set value.
d) If the RCU receives the “send keycode” command, it outputs the IR signal of the
corresponding key. However, the RCU will not store the set value.
e) The TV database uses the set number from 0001 to 1999.
f) The Audio database uses the set number from 3001 to 4999
3.9 – Remove the TV & Audio
a) Press [OK] and [V-] keys for longer than 4 seconds. LED stays ON while pressing [OK]