User's Manual

When the component turns off, save the code
number you entered by pressing the SAVE button
that appears on the screen.
Exit SET UP mode by pressing the MAIN button
two times. When the display shows “MAIN”, you
are back in normal operating mode. Now it’s time
to test the all the buttons. If some buttons don’t
work, try another three digit code to see if it gives
better operation.
For Example: My Sony TV powers off with code
139. However after trying 139, not all buttons
work. I repeated steps 1 to 10 trying other code
sets and eventually discovered that the 185 code
set operates ALL my buttons.
Repeat steps one through ten for each of your
devices. In most systems, you can finish basic
programming in just a few minutes and put all
your old remote controls away. Once you have
finished all of the devices, you can move on to
page 13 to set up your volume punch through.
If you can’t find any code that powers off a
component, try the Scan method on the next
page. If you are missing one or two commands,
use the learning method on page 10.
SAVE
Button
Code You
Entered
8
The Automator
10
11
9