User's Manual

The Automator

Press and hold the button on your old remote con-

trol until the display changes to “RETRY”.

Press and hold the same button on your old remote

control once again.

Note: DoubleTap learning is exclusive Automator tech-

nology bringing you the most reliable operation.

Once you have taught the button twice, the display

will change to either “GOOD” or “FAILED”.

If the “GOOD” label appears on top of the display

and “SAVED” flashes on the bottom, you were suc-

cessful. Now, you can select another button to teach.

If the “FAILED” label appears on top of the display

screen, try to teach the same button in Automator

once again by repeating steps six and seven.

Continue to teach any commands from any of your

remote controls by repeating steps five, six and

seven (to go back to step five, press MAIN once).

Once you completed teaching all the buttons you

wish, return to normal operation by pressing the

MAIN button twice. Test all your new commands, if

any of them don’t work, try learning again using

these notes:

Move to another room. Plasma TVs, sunlight, halogen or

quartz lighting can interfere with the learning process.

Although the old remote control seems to work fine,

change the batteries to fresh alkaline batteries.

Vary the distance between the remote controls

gradually. Try 1/4”, 1”, 2”and so on, up to 4 feet.

Tap the button on the original remote control instead of

pressing and holding it during the learning process.