User's Manual

Macro Button Set Up

Imagine pressing just one button but watching your TV

turn on, then the DVD player and then the A/V sur-

round sound receiver. What would normally take three

remotes and three button pushes, the Automator can

accomplish with the press of one button. We call that a

“Macro”. Any labeled button, the Power On or the

Power Off buttons (on any Device or Page) can be set

to be Macro buttons!

To set up a macro button, follow these easy steps:

Enter the SET UP mode by pressing and holding

MAIN and ENT. As usual, you have 30 seconds.

Press the MACRO button.

The top of the display screen will show “MACRO”.

The bottom of the display screen will flash

“SELECT”.

Navigate to the Device and Page where there is a

button you would like to set as a Macro button

using the MAIN, DEVICE and PAGE buttuns.

Note: If you wish to set up one of the DEVICE buttons as

a macro, press the Page Up button twice. The top of the

display changes to MAIN, and you can navigate to MAIN

page 1 or page 2 before going on to Step 4.

The Automator

MACRO

Button