User's Manual

URC-200

Basic Set Up

You can set up your Automator using either the learning

or the pre-programmed method. Because all the buttons

can be set up in one quick operation rather than one

button at a time, we recommend you start with

pre-programmed set up before you do any learning.

Pre-Programmed Standard Method

Turn on the component you wish to set up in your

Automator (TV, VCR, DVD, etc.)

Look up the code table shown on pages 33 - 49 and

take note of the three digit codes listed for your

component and brand.

Press and hold the MAIN and ENT (Enter) buttons

at the same time for approximately three seconds.

The top of the display screen will show “SET UP”.

You are in SET UP mode now.

Note: You have 30 seconds to perform a step while you are in

SET UP mode. If you don’t press a button within that time, the

Automator will time out and return to normal operation.

MAIN

Button

ENT

Button