User's Manual

URC-200

The bottom of the display should now be flashing

FROM TABLE. This prompts you to select the

CODE TABLE via the Cursor and SELECT buttons.

For Example: Let’s pretend you are programming a

TV. You would find the the three digit codes for

Televisions in the TV CODE TABLE. So you would

press the cursor buttons until “TV” is flashing,

then press the SELECT button. This selects the TV

CODE TABLE. Now you are ready to test codes!

Point the remote control at the component, then

enter the first three digit code number from your

notes using the numbered buttons. Continue to

enter codes until the component powers off.

For Example: Let’s pretend you have a Sony TV. You

would find the the three digit codes 070, 139,147,

126, 185, 194 and 085 under Sony in the TV CODE

TABLE. Using the numbered buttons on the Automator,

enter the 070 and watch the TV. If it doesn’t turn off,

enter 139, then try 147 and so on.

Note: If none of the codes turn off the component, you

should try the Scan Method (see page 9).

SELECT

Enter the

Code via

the

Numbered

Buttons

DOWN