User's Manual

Installing the CP-2
Physical Installation of the CP-2 and Accessories
The CP-2 Central Processor can be installed anywhere in the home
or office network. Once installed, program it to operate all local
equipment using IP/Network, IR, RS-232, or Relays. As well as query
the status of a device using Sensors. All cables are plugged into their
respective ports in the rear of the unit.
Network Installation
1. Connect an Ethernet cable (RJ45) to the rear of the CP-2 and onto
the network.
2. Plug flashers into any of the six IR outputs on the rear of the CP-2.
(Make sure the 3.5mm pink connector cable is reserved for port
#6.)
Page 4
CCGEN2 CP-2 ADVANCED NETWORK SYSTEM CONTROLLER