User Manual

USER MANUAL
HOT STAPLER
H-008
V/ HOW TO USE
Preparing the plastic:
Make sure the area to be stapled is free of paint and clean. Removeany oils or
residues from the plastic’s surface.
Getting Started:
Plug in control box and turn on. Carefully insert desired staple into one of
three possible positions in the end of the stapler without depressing the power
button on the handle. Once pressed to the bottom of the hole, the unit is ready
for use.
Turn the control dial to the second or third
position, unless very low heat levels are
desired. These two positions satisfy most
stapling applications.
Lay staple over the desired location and
apply gentle pressure. Push the button
on the handle, then release once the
staple is at the desired depth. Allow to
cool slightly. Pull back and the staple
will remain in the plastic. Clip off the
staple with the supplied diagonal cutter.
When clipping off the staple prongs,
wear eye protection and cup your hand
over the staple to prevent the clipped
wire from becoming a projectile.
5
6
Setting the Temperature:
Use:
Caution:
Distributor info:
More information please contact with the distributor