Operation Manual
20
EN
PREPARATION
Putting salt into the salt container
2
Depending on your tap water hardness (hardness degree) use additional salt (water softener).
Always consider instruction provided with the salt.
1. Remove the basket and then unscrew and remove the cap from the salt container.
2. Before rst wash, add 1.5 lt. of water in the salt container of your machine.
3. Place the end of the funnel (supplied) into the hole and introduce about 1.5 kg of salt. It is
normal for a small amount of water to come out of the salt container.
4. After lling the container, screw the cap tightly back clockwise.
5. Immediately after lling the salt into the salt container, a washing program should be started
(rapid program suggested). Otherwise lter system, pump or other important parts of the
machine may be damaged by salty water which is out of warranty.
Note: Depending on how fully the salt dissolves, the salt warning light may still be on even though
the salt container is lled.
Warning!
• Only use salt specically designed for use in dishwashers! All other types of salt not specically
designed for use in a dishwasher, especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is
liable for any caused damages.
• If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
• Only ll with salt just before starting one of the complete washing programs. This will prevent any
grains of salt or salty water, which may have been split, remaining of the bottom of the machine for
any period of time, which may cause corrosion.
• The salt container must only be relled when the salt warning light in the control panel comes on.
IM_ODW60012_160118_V05_HR.indb 20 18/1/16 2:12 PM