Operation Manual
21
EN
Adjusting salt consumption
3
1. Activate the setup mode: Close the door within 60 seconds after power ON, press Start/Pause
button and hold for 5 seconds, the machine will enter setting mode which is indicated by the
alternatingly blinking indicator lights of
and .
2. Adjust level of salt consumption: Press the Start/Reset button to select the proper setting
according to your local environment. Follow table below to nd correct setting.
Water Hardness level
Setting Digital display stalls
Salt consumption
Gram/Cycle
°dH
1)
mmol/l
2)
0-5 0-0.94 1
Kurz 45°C (short 45°C) 0
6-11 1.0-2.0 2
90 min 9
12-17 2.1-3.0 3
90 min and Kurz 45°C 12
18-22 3.1-4.0 4 * Gläser (Glass) 20
23-34 4.1-6.0 5
Gläser (Glass) and
Kurz 45°C (short 45°C)
30
35-55 6.1 - 9.8 6 Gläser (Glass) and 90 min 60
3. The product will exit the setup mode automatically 5 seconds after last setting/operation of
switch.
Note:
1)
German degree of measurement for the water hardness
2)
Millimol, international unit for water hardness
*
)
Factory setting
Contact your local water board for information on the hardness of your water supply.
Adding detergent
4
• The dispenser must be relled before the start of each wash cycle.
• For the correct amount follow the instructions provided with the detergent.
1. Press release button. The lid springs open.
2. Always add the detergent just before starting each wash cycle, otherwise it could get damp
and will not dissolve properly.
3. If the dishes are heavily soiled, place an additional detergent dose in the pre-wash detergent
chamber. This detergent will take eect during the pre-wash phase.
Consider the dierence of two compartments:
a) Compartment for detergent for main wash cycle.
b) Compartment for detergent for pre-wash cycle.
4. Close the lid and press until it locks in place.
Note: Use only detergent specically made for use in dishwashers. Keep your detergent fresh and dry.
IM_ODW60012_160118_V05_HR.indb 21 18/1/16 2:12 PM