Operation Manual

27
EN
Cleaning the spray arms
13
The spray arms can be easily removed for periodic cleaning of the nozzles, to prevent possible clogging.
• Grasp the middle of the spray arm, pull it upwards to remove it.
• Wash the arms under a jet of running water.
• Return them carefully to their seat and make sure that the spray arms are installed correctly and
can turn freely.
ERROR CODES
Code Meaning Possible causes
The Kurz 45°C light ickers Longer inlet time
• Faucets is not opened
• Water intake is restricted
• Water pressure is too low
The Gläser light ickers Overow
• Some component of dishwasher leaks
TROUBLESHOOTING
If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem Possible causes Solution
Product does not work • Interrupted power supply • Check the power supply
• Water pressure is low • Check whether water supply
is connected properly and
water is turned on
• Dishwasher door is not
closed properly
• Ensure door is closed
properly
Water not pumps from
dishwasher
• Kink in drain hose • Check the drain hose
• Filter is clogged • Check and clean the coarse
lter
• Kitchen sink is clogged • Check the kitchen sink is
draining well or call a service
agent for help
Sud in the tub` • Improper detergent • Only use special dishwasher
detergent
• Spilled rinse aid • Wipe up rinse-aid spills
Sud tub interior • Detergent with colourant
was used
• Only use detergent without
colourant
White lm on inside surfact • Hard water minerals • Clean the interior with a
damp sponge regulary
Rust stains on cutlery • Cutlery are not corrosion
resistant
• Do not wash these items in
dishwasher
• A programme was not run
after ll in salt
• Always run a short
programme (Kurz 45°C ) after
adding salt
• Softener lid is loose • Check and x it
IM_ODW60012_160118_V05_HR.indb 27 18/1/16 2:12 PM