Operation Manual

16
EN
CD MODE
9
Switching on the appliance: Press and hold the / button for approx. 2 seconds. Power
indicator lights up.
Set the function switch to the CD position. Power indicator lights up.
10
Open the CD compartment door and insert a CD with a label facing up.
11
Close the CD compartment door.
Note: If no CD is inserted, the display shows
.
CD PLAYBACK
12
1. Start or pause playback: Press . In pause mode, the play/pause indicator will ash on the
display.
2. Stop playback: Press . In stop mode, total number of tracks will be shown on the display.
3. Skip to next track: Press . Press and hold to fast forward.
4. Skip to previous track: Press . Press and hold to fast reverse.
13
During playback, press REP repeatedly to switch the playback modes:
Press Repeat indicator Result
1x Flashes. Repeat one track.
2x Continuously on. Repeat all tracks.
3x Goes o. Normal playback.
Note: If no CD is played for more than 10 minutes the appliance will switch itself o automatically.
PROGRAM PLAYBACK
Notes:
• Up to 20 CD tracks can be programmed for a playback in any desired order.
• The program function can be combined with the repeat function.
14
1. Stop playback: Press .
2. Enter program settings: Press PROG. 01 ashes in the display.
3. Select desired track: Press or .
4. Store selected track into the program memory: Press PROG again. Now, 02 ashes in the
display.
5. Repeat step 3 and 4 to program additional tracks.
6. After programming all the desired tracks, press to start program playback.
7. Stop playback: Press 1x .
8. Cancel program playback: Press 1x again.
AUXILIARY AUX PLAYBACK
15
Switching on the appliance: Press and hold the / button for approx. 2 seconds. Power
indicator lights up.
Set the function switch to the AUX position.
16
Connect auxiliary device to the AUX-IN socket using 3.5 mm jack audio cable (not included).
If an auxiliary device is connected, all playback functions of this device need to be used.
IM_ORC110_140605_V03.indb 16 6/5/14 11:15 AM