Operation Manual

31
GB
Failure removal
Failures
Causes
Removal
The motor does not start.
Closed fuel tap Make sure the fuel tap and On/O are in
the „ON“ position
Lack of fuel Add some fuel
Weak tension on the starter Pull strongly the starting cord.
Wrong fuel, storing without petrol tank
being drained
Drain the fuel tank and carburettor, add
fresh petrol
Sooted spark plug (carbon residues on
electrodes), electrodes distance too big
Clean the spark plug, check the plug ther-
mal value, possibly change the plug, set
the electrodes distance to 0.6-0.7 mm
The spark plug is wet from petrol (over-
saturated engine).
Dry the spark plug out and re t it.
Little oil in the engine Add oil
Unit is not in a horizontal position. Lack
of oil being signalled
Place the unit in a horizontal position
Choke has not been used
Use the choke
8
Engine running irre-
gularly
Too small appliance
Problem with ignition
Make sure the spark plug is  tted pro-
perly. Make sure the spark plug cable is
on the spark plug. Clean the spark plug
and check the electrodes if correct.
Wrong fuel (propellant) Make sure proper fuel has been used.
Unit not producing any
current.
Short circuit
Broken cable
Loose cable
Indicator is o :
An error that you can remove yourself.
Contact the GÜDE service centre.
Indicator is on:
1. Press the overloading protection for
the used output.
2. Check the cables.
3. Check for a short circuit or overloa-
ding.
Engine stopping The Starting current is too big. Reduce the appliance
Too long cable Shorten the cable
E-starting not working Empty or defective battery Charge or replace the battery
ENGLISH