Installation Instructions

OmniTourGuidingSystemOTG‐200

19

 Troubleshooting

NODATAshowsupontransmitter 

 Thisscreenmightshowupontransmitteranditmeansnopriorpairingwascompleted.Please
pairingbeforerequestedoperationisdone.
 NOTAPPLICABLEshowsupontransmitter 


Thisscreenmightshowupontransmitteranditmeansthefunctionisnotapplicable. 
 BUSYshowsupontransmitter 

 Thisscreenmightshowupontransmitteranditmeansthetalkrightisoccupied,pleaseask
thatoccupiedtransmitter/receivertoreleasethistalkright.
 DATAERRORshowsupontransmitterorreceiver


Transmitter 
Pairingdatafailstoacquire.Pleaseturnthetransmitteroffandre‐turnitonagainforsuccessful
acquirementofpairingdata.Notesamecommunicationmodeandchannelneedtobeseton
bothtransmitters(ifthecommunicationmodeis“Teaching”,themaster/slaveswitch(
○
10
)on
bothtransmittersneedstobetunedat“m”).
 Receiver 
Pairingfailstocomplete.Pleaseturnthereceiveroffandre‐turnitonagainforsuccessful
pairing.
 Receivercan’thearTransmitter 
 Makesurethevolumecontrol(○
14
)istunedatappropriatelevel.
 Makesurethechannelnumberonbothtransmitterandreceiverissame.
 Makesurethe“communicationmode”(G,TorD)shownonbothtransmitterandreceiveris
same. 
 Receivercan’ttalkbackviaPTTbutton 
 IfthereceiverissetatGUIDINGmode,makesuremastertransmitteristuneditsmaster/slave
switch(○
10
)from“m”to“s”andnootherreceiveroccupiesthetalkright.