Instruction Manual

4 - 16
Setting
Example: Method for setting the parameter to 19 (for case where the previous
parameter setting was 8).
LCD display after operation
Turn the POWER switch
on while holding the
FORM FEED and ENTER
keys down.
Press + or - key, until "19"
is displayed.
Press the ENTER key.
Turn the POWER switch on
while pressing the FORM
FEED and ENTER keys.
Operation
Displays previous
parameter No.
Parameter 19 is
set to EEPROM
(* is displayed on
LCD).
ENG MNT
OPT HEAD
600-4W
LED HEAD
No. 8 *
LED HEAD
No. 19
LED HEAD
No. 19 *
HEAD TYPE
TYPE1
ON-LINE
XXX
Press the MENU key.
XXX: HP4, AUT, WIN or HEX DUMP
When the numeral of upper two digits
under the bar code is 73, TYPE 1 is selected.
When the numeral of upper two digits
under the bar code is 74, TYPE2D4 is selected.
The item of “OPT HEAD” is
always 600-4W when the
600dpi head is used.
There are two types of “HEAD TYPE”
available (TYPE-1, TYPE2D4).
The type is set as shown below
according to the content of the
bar code label attached on the head.
Content of the bar code label on the head
xxxxxx
. . . . .
73000123400101100