Operation Manual

INSTALLATION AND RELOCATION PROCEDURE > 14
INSTALLING THE FACE UP (REAR) TRAY
You can install the face up (rear) tray on this printer if required.
1.
Insert the right and left tabs of the face up (rear) tray into the
holes at the back of the printer (1), and lower the tray into
position (2).
2.
Push up the rear output tray lever as shown in the diagram (1)
and pull out the extension tray (2).
3.
Affix the label provided to the back of the printer.
NOTE
A face up (rear) tray can be installed on the B6300 only.