Operation Manual

INSTALLATION AND RELOCATION PROCEDURE > 26
INSTALLING A NETWORK SOFTWARE KIT, HARD DISK,
COMPACT FLASH DISK, OR ADDITIONAL MEMORY
To install a Network Software Kit, Hard Disk, Compact Flash Disk or
Additional Memory, the same steps are required at the beginning, to
prepare the printer, and at the end, to close the printer, of each
installation. These steps are described here.
Preparing the printer
1.
Remove the screw on the right detachable cover.
2.
Slide the cover towards the back of the printer (1) to release
the protrusions at the bottom and pull it downwards (2).