Operation Manual

INSTALLATION AND RELOCATION PROCEDURE > 30
INSTALLING A HARD DISK
You can install a hard disk option on this printer.
1.
Refer to “Preparing the printer” on page 26.
2.
Remove the screws on the right and left sides of the Compact
Flash disk drive (1) and remove the Compact Flash disk drive
as shown in the diagram (2).
3.
Remove the cable of the Compact Flash disk drive from the
connector on the printer.
NOTE
> When the Compact Flash disk (option) is installed on your printer,
you cannot install the hard disk. You can install only one of them.
> Installing this option may initialise the settings of [Network/Port]
and Allocate Memory].
CAUTION!
The hard disk is a delicate item and must be handled with care. In the
event that damage does occur, it may erase important data saved on
the disk. It is recommended that you back up your data regularly.