Extra Information

- 135 -
Other Operations
4
4. Network Settings
8 Click [Start] and select
[Administrative Tools]>[DHCP] to
launch the [DHCP] wizard.
9 On the DHCP list, select a server to use.
10 From the [Action] menu, select [New
Scope].
11 On the [New Scope Wizard], follow the
on-screen instructions and congure the
settings as necessary.
Memo
● Be sure to congure the default gateway settings.
● On the [Activate Scope] screen, select [Yes, I
want to activate the scope now].
12 Click [Finish].
13 Select the new scope from the DHCP list
and then select [Reservations].
14 From the [Action] menu, select [New
Reservation].
15 Congure the settings.
16 Click [Add].
17 Click [Close].
18 From the [File] menu, select [Exit].
Conguring Your Printer
The following explains how to congure your
printer to use DHCP/BOOTP.
Note that since the DHCP/BOOTP protocol is
enabled by factory default, you do not have to
perform this procedure.
Memo
● The following steps are explained using Network Card
Setup as an example. The steps and menus may differ
depending on the software you use.
1 Turn on the printer.
2 Turn on your computer and insert the
software DVD-ROM.
3 Click [Run Setup.exe].
If the [User Account Control] dialog box
appears, click [Yes].
4 Read the license agreement and click
[Agree].
5 Read the [Environmental advice for
Users] and then click [Next].
6 Select a device to be used and then click
[Next].
7 Select [Network connection] and the
click [Next].
8 Click [Device Network Setup].
9 Select your printer from the list and click
[Next].
10 Enter the IP address and then click
[Setup].
11 Enter the password at [Password] and
then click [OK].
- The factory default password is the last six
digits of the MAC address.
- The password is case-sensitive.
The network card reboots to enable the new
settings.
12 Click on [Exit].