Extra Information

- 134 -
Other Operations
4
4. Network Settings
 Other Operations
This section explains how to initialize the network settings and how to set up your printer and computer
to use DHCP.
Initializing Network Settings
Note
● This procedure initializes all the network settings.
1 Press the scroll button .
2 Press the scroll button to select
[Admin Setup] and then press the
<ENTER> button.
3 Enter the administrator password using
the ten-key pad.
The factory default administrator password is
“aaaaaa”.
4 Press the <ENTER> button.
5 Make sure that [Network Setup] is
selected and then press the <ENTER>
button.
6 Press the scroll button to select
[Factory Defaults?] and then press the
<ENTER> button.
7 Make sure that [Execute] is selected
and then press the <ENTER> button.
The network settings are initialized.
Using DHCP
You can obtain an IP address from the DHCP
server.
Note
● Administrator privileges are required.
Memo
● You can obtain an IP address from the BOOTP server.
Conguring DHCP Server
DHCP assigns an IP address to each host on the
TCP/IP network.
Note
● The printer must have a static IP address if you want to
print via a network. For details on how to assign a static
IP address, refer to the manual of your DHCP server.
Memo
● The following OSs are supported:
- Windows Server 2008 R2, Windows Server 2008, and
Windows Server 2003
● The following steps are explained using Windows Server
2008 R2 as an example. The steps and menus may differ
depending on the OS you use.
1 Click [Start] and select
[Administrative Tools]>
[Server Manager].
If [DHCP] is already shown in [Administrative
Tools], continue to step 8.
2 Select [Add Roles] on the [Roles
Summary] area.
3 On the [Add Roles Wizard], click
[Next].
4 Select [DHCP Server] and then click
[Next].
5 Follow the on-screen instructions and
congure the settings as necessary.
6 On the [Conrm Installation
Selection] screen, check the settings
and click [Install].
7 When the installation nishes, click
[Close].