Operation Manual

Daily care > 62
D AILY CARE
C LEANING THE PRINTER
This section describes how to clean the printer in order to maintain it in good condition and
print clean printouts all the time.
C LEANING THE EXTERIOR
Clean the exterior of the printer about once a month. Wipe the parts with a wet but well-
wrung soft cloth. Then wipe with another dry soft cloth. For stubborn stains, moisten a soft
cloth with a small amount of neutral detergent, and gently wipe the stain off.
C LEANING THE INTERIOR
After clearing paper jams or replacing the drum unit/toner cartridge, inspect the inside of
the printer before closing the Front cover.
> Remove any remaining pieces of paper.
> Remove any dust or stains with a clean dry cloth.
WARNING!
Be sure to switch off and unplug the machine before accessing the
interior of the machine for cleaning, maintenance, or fault
clearance. Access to a live machine’s interior can cause electric
shock.
CAUTION!
Do not spray the detergent directly on the printer. The liquid
detergent may enter the printer through a gap and cause problems.
Never use cleaning agents other than water or neutral detergent.
WARNING!
Never touch areas labelled as ‘High Voltage’. You can get an
electric shock. Never touch a labelled area found on or near the
heat roller. You can get burned. If a sheet of paper is wrapped
around the heat roller, do not try to remove it by yourself to avoid
injuries or burns. Switch off the machine immediately, and contact
service.