Operation Manual

Daily care > 63
W HEN MOVING THE PRINTER
Carry out the following procedure when moving the printer.
Correct moving procedure
Carry out the following procedure when moving the printer.
1. Press the power switch of this printer to the <O> position to switch the power off.
2. Remove all cords, such as the power cord and interface cables.
3. Remove any paper in the centre output tray and MFP tray (tray 5).
4. Pull out the paper tray from the printer and remove any paper in the tray.
Keep the paper wrapped and away from humidity and dirt.
WARNING!
> The machine, without the optional accessories, paper trays,
consumables and paper, weighs 41.0 kg or 90lbs. When moving
the equipment, make sure that there are two or more persons
carrying it.
> If the duplex unit (optional) or A4 tray (optional) has been
installed, uninstall it before moving the printer. If these are not
fixed securely to the printer, they may fall to the ground and
cause injuries.
> When lifting the machine, be sure to observe the following
points, failure to do so may cause the machine to fall and result in
injuries.
• 2 persons, one facing the front of the machine (control
panel) and the other facing the back, should firmly grip the
recessed areas on the bottom part of both sides of the
machine. Never try to lift the machine by gripping any other
areas.
• Bend your knees to avoid possible injuries to your back.
CAUTION!
Do not tilt the machine more than 10 degrees.
WARNING!
Never touch a power cord with wet hands. Danger of electric shock
exists. When unplugging the machine, grasp the plug instead of the
cord. Forcibly pulling on a chord can damage it and cause fire or
electric shock.