Operation Manual

Replacing Consumables 6-11

" It is not possible to exit REMOVE ALL mode before the operation is

finished (even if the Cancel key is pressed).

If the printer has incorrectly been switched to REMOVE ALL mode,

open, then close the front cover (step 2 on page 6-5 and step 10 on

page 6-9) four times to exit REMOVE ALL mode.

2 Perform the operations described in steps 2 through 10 of “Replacing a

Toner Cartridge” on page 6-4 through 6-10 to replace the magenta toner

cartridge.

3 Follow the same procedure to replace the cartridges for the cyan, black,

then yellow toners.

" The printer must complete a calibration cycle (less than 2 minutes)

after a toner cartridge has been replaced. If you open the top or

front cover before the printer is reset, the calibration stops, then

starts over again after the cover is closed.

4 Press the key three times to exit the configuration menu.

REMOVE ALL

*NO

REMOVE ALL

YES

*YES

IS SELECTED

Then, it displays

OPEN DOOR AND

REMOVE M TONER

Press Key Until Display Reads

ENTER