Operation Manual

Loading paper > 18

ULTI

PURPOSE

TRAY

1. Open the multi purpose tray (a).

2. Fold out the paper supports (b).

3. Press gently down on the paper platform (c) to ensure it is latched down.

4. Load the paper and adjust the paper guides (d) to the size of paper being used.

> For single-sided printing on headed paper load the paper into the multi purpose

y with pre-printed side up and top edge into the printer.

> For two-sided (duplex) printing on headed paper load the paper with pre-printed

side

down and top edge away from the printer.

> Envelopes should be loaded face up with to

p edge to the left and short edge into

the printer. Do not select duplex printing on envelopes.

> Do not exceed the paper capacity of about 100 sheets or 10 envelopes. Maximum

stack

ing depth is 10mm.

5. Press the tray latch button inwards to release the paper platform, so that the paper

lifted and gripped in place.

6. Set the correct paper size for the multi purpose tray in the Media Menu.

NOTE

> Do not press the paper from the top or pull the paper by holding it while

the pr

inter is printing from the MP tray. If you want to stop printing, open

the output tray.

> For instructions on how to remove the paper, refer to “Cleari

ng paper

jams” on page 70.