Operation Manual

Operator panel > 29
TRAY
CONFIG
(c
ont.)
TRAY2
CO
NFIG
(cont.)
Y DOMENSION 210 MILLIMETER
~
279 MILLIMETER
~
297 MILLIMETER
~
356 MILLIMETER
Specifies paper length of Custom paper as a
de
fault value.
Sets a paper size in the same direction as the
paper ru
n direction.
MEDIATYPE PLAIN
LETTERHEAD
BOND
RECYCLED
CARD STOCK
ROUGH
GLOSSY
USERTYPE1
USERTYPE2
USERTYPE3
USERTYPE4
USERTYPE5
Selects the type of media loaded in this tray (if
insta
lled). This will help the printer to adjust its
internal operating parameters, such as engine
speed and fusing temperature, to better
accommodate the media to be fed.
For example, letterhead may benefit from a
s
light
ly lower fusing temperature to ensure
that its ink does not offset.
Note: USERTYPEn are displayed only if
register
ed in the host PC/Server.
MEDIAWEIGHT LIGHT
MEDIUM LIGHT
MEDIUM
HEAVY
ULTRA HEAVY1
Adjusts the printer for the weight of paper
s
toc
k loaded in this tray (if installed).
PAPERFEED MP TRAY
TRAY1
TRAY2
Selects the default tray for paper feed, Tray 1
(u
pper
), Tray 2 (lower, if installed) or MP tray
(multi purpose tray).
AUTO TRAY SWITCH ON
OFF
If two trays contain identical paper, the printer
can swi
tch to an alternative source when the
current tray runs out in the middle of a print
job.
TRAY SEQUENCE DOWN
UP
PAPER FEED TRAY
Determines tray sequence order when
auto
matically switching.
DUPLEX LAST PAGE SKIP BLANK PAGE
ALWAYS PRINT
When SKIP BL
ANK PAGE is selected and a
print job has an odd number of pages, the final
page will be printed as Simplex.
When ALWAYS PRINT is
selected and the
print job contains an odd number of pages, the
final page will be printed as Duplex.
STSTEM
AD
JUST
POW
SAVE TIME 1 MIN
2 MIN
3 MIN
4 MIN
5 MIN
10 MIN
15 MIN
30 MIN
60 MIN
Adjusts the idling time before the printer
automatically switches into power saving
mode. In this mode power consumption is
reduced to a low level required to just keep the
printer operating and ready to receive data.
When a job is sent the printer will require a
warm-up time of up to 1 minute before
printing can begin.
ITEM SETTINGS EXPLANATION