Operation Manual

Operator panel > 42
PCL S ETUP
ITEM SETTINGS EXPLANATION
FONT SOURCE RESIDENT Specifies the location of the PCL default font.
Normally this will be INTERNAL unless additional
fonts are installed in the expansion ROM slot or
additional fonts have been downloaded to RAM as
permanent fonts.
FONT NO. I0
~
I90
Sets the current default font number from the
cu
rrent
ly selected source.
FONT PITCH 0.44 CPI
~
10.00 CPI
~
99.99 CPI
Sets the width of the PCL default font in
c
har
acters/inch (CPI).
Default font is the fixed-pitch, scalable font. The
valu
e is displayed to the second decimal place.
Displayed only when the font selected in Font No.
is fi
xed-spacing, scalable font.
FONT HEIGHT 4.00 POINT
~
12.00 POINT
~
999.75 POINT
Height of the PCL default font.
Note: This menu item is displayed only when the
fo
nt s
elected in Font No. is a proportional-
spacing, scalable font.
SYMBOL SET PC-8
(Default Symbol
Se
t
only
shown)
Selects a PCL symbol set.
A4 PRINT WIDTH 78 COLUMN
80 COLUMN
Sets the number of columns subject to Auto LF
with
A4 paper in PCL. This is the value when Auto
CR/LF Mode is set to OFF with the 10CPI
character.
WHITE PAGE SKIP ON
OFF
Selects whether blank pages are printed or not.
CR FUNCTION CR
CR+LF
Selects whether a received carriage return
c
haract
er (0Dh) also causes a line feed.
LF FUNCTION LF
LF+CR
Selects whether a received line feed character
(0A
h) al
so causes a carriage return.
PRINT MARGIN NORMAL
1/5 INCH
1/6 INCH
Sets the non-printable page area. NO
RMAL is
PCL c
ompatible.
TRUE BLACK ON
OFF
PCL: Sets if to use Composite Black (CMYK
mixed)
or Pure Black (K only) for the black
(100%) in image data.
PEN WIDTH ADJUST ON
OFF
When minimum width is specified in PCL,
s
ometi
mes a 1-dot line, looks broken.
With PEN WIDTH ADJUST set
to ON, when the
minimum width is specified, the line width will be
emphasized so as to look wider than a 1-dot line.
With PEN WIDTH ADJUST set
to OFF, the line
will appear as before.