Operation Manual

Maintenance > 60
F USER REPLACEMENT
The fuser is located inside the printer just behind the toner cartridges.
1. Press the cover release and open the printer’s output tray fully.
2. Identify the fuser handle (
a)
on the top of the fuser unit.
3. Pull the two fuser retaining levers (b) towar
ds the front of the printer so that they
are fully upright.
4. Holding the fuser by its handle (a),
lift the fuser straight up and out of the printer. If
the fuser is still warm, place it on a flat surface which will not be damaged by heat.
5. Remove the new fuser from its packaging and remove the transit material.
6. Holding the new fuser by its handle, make sure that it is the correct way round. The
retai
ning levers (b) should be fully upright, and the two locating lugs (c) should be
toward
s you.
7. Lower the fuser into the printer, locating the two lugs (c) i
nto their slots in the sides
of the printer cavity.
WARNING!
If the printer has recently been powered on, some fuser
components will be very hot. Handle the fuser with extreme care,
holding it only by its handle, which will only be mildly warm to the
touch. A warning label clearly indicates the area. If in doubt, switch
the printer off and wait at least 10 minutes for the fuser to cool
befor
e opening
the printer cover.
b
b
a
b
b
c