Operation Manual

Using the printer software > 77
S YSTEM CONFIGURATION MENU
This menu adjusts general printer settings to suit the way you
prefer to work.
SYSTEM CONFIGURATION MENU
ITEMS SETTINGS EXPLANATION
STATUS PAGE
AUTO PRINT
ENABLED
DISABLED
Automatically prints status on power up.
TIME TO POWER
SAVE MODE
5 MIN
15 MIN
30 MIN
60 MIN
240 MIN
Adjusts the idling time before the printer
automatically switches into power saving
mode. In this mode power consumption is
reduced to a low level required to just
keep the printer operating and ready to
receive data. When a job is sent the
printer will require a warm-up time of up
to 1 minute before printing can begin.
CLEAR ALARMS ON
JOB
When ON, non-critical warnings, such as
requests for a different paper size, can be
cleared by pressing the ON LINE button.
When set to JOB, they are cleared when
the print job resumes.
MANUAL FEED
(Multi Purpose
Tray) TI MEOU T
OFF
30~90~300 SEC
Specifies how many seconds the printer
will wait for paper to be fed in manual
feed mode before cancelling the job.
PRINT TIMEOUT OFF
5~90~300
Specifies how many seconds the printer
will wait when received data pauses
before forcing a page eject. In PostScript
Emulation mode the job will be cancelled
if timeout occurs.
PRINT
CONTINUATION
AT TONER
SHORTAGE (LOW
TONER)
CONTINUE
CANCEL
Specifies whether the printer should
continue printing even after a low toner
condition is detected.
JAM RECOVERY ON
OFF
Specifies whether the printer should
perform jam recovery after a paper jam
has occurred. If ON, the printer will
attempt to print again any pages lost due
to a paper jam once the jam has been
cleared.
ERROR REPORT ON
OFF
Specifies whether to print an error report
when an internal error occurs.
LANGUAGE English, German,
French, Italian,
Spanish, Swedish,
Norwegian,
Finnish, Danish,
Dutch, Turkish,
Portuguese,
Polish, Russian,
Greek
Sets the language used for the Status
Monitor and printed reports.