Operation Manual
Table Of Contents
- Preface
- Emergency First Aid
- Manufacturer
- Importer to the EU/Authorised Representative
- Environmental Information
- Contents
- Notes, Cautions and Warnings
- Introduction
- Getting Started
- Configuring your machine....
- Menu Structure
- Operation
- Maintenance
- Troubleshooting
- Installing additional memory
- Colour Printing
- Specifications
- Index
- Oki contact details
Operation > 68
or
0 mm, 6 mm, 13 mm, 19 mm, 25 mm
Margin shift - bottom: This sets the amount to shift the
document up.
Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in
or
0 mm, 6 mm, 13 mm, 19 mm, 25 mm
4. Press the Left arrow key to return to the start menu.
O
PERATION
1. Place your document(s) with the text face Up in the ADF
or face Down on the glass (as described above).
2. If you wish to make one copy of the document(s), simply
press the Start button (monochrome or colour option).
3. If more than one copy is needed, first set the number of
copies by pressing the Enter button and setting the
number of copies required (1-99).
4. Then press the Start button (monochrome or colour option).
NOTE
When using the ADF, in order to prevent
paper jams, if you wish to cancel the copy
process, press the Stop/Cancel button once
to stop the process and a second time to
eject the paper.
NOTE:
Any parts of the image that do not fit on the paper as a result
are printed. The setting displayed, mm or inch, depends on
the setting in Admin Setup - System Setup - Unit of Measure
in Menu Mode.
If Margin Shift-Right is set to other than "0 mm" or "0.00 in,"
Edge Erase always defaults to "0mm (0.00in)" and Reduce/
Enlarge can be set only to less than 100%.