Operation Manual
Table Of Contents
- Table of contents
- Before starting
- Setting Up
- Installation Requirements
- Checking the Accessories
- Unpacking and Installing the Machine
- Installing the Optional Equipment
- Connecting the Power Code
- Connecting a LAN Cable/USB Cable
- Loading Paper in the Tray
- Setting Up This Machine
- Connecting to a Wireless LAN (Only When the Wireless LAN Module is Mounted)
- Installing a Driver and Software to a Computer
- Basic Operations
- Maintenance
- Troubleshooting
- Operating Management/Specifications
- Contact Us
- 37 -
2. Setting Up
Connecting to a Wireless LAN (Only When the Wireless
LAN Module is Mounted)
• Before Connecting to a Wireless LAN
• Enabling Wireless LAN Connection
• Connecting to an Access Point (Infrastructure)
• Connecting to the Machine Directly
• Wireless(Infrastructure) and Wireless(AP Mode) cannot be enabled at the same time.
• If the machine is used in a wireless network environment, the machine does not enter Deep Sleep mode but enters
Sleep mode.
• Do not place any electric products that emit weak radio waves (such as microwaves or digital cordless telephones)
close to the machine.
• The communication speed of a wireless LAN connection may be slower than that of a wired LAN or USB connection
depending on the environment. If you want to print big data such as a photo, it is recommended to print with a wired
LAN or USB connection.
Connecting to an Access Point
Before connecting this machine to a wireless LAN access point, check the following.
1
Check if your wireless LAN access point matches the following requirements.
Standards: IEEE 802.11 a/b/g/n
Access method: Infrastructure mode
Before Connecting to a Wireless LAN