Operation Manual
Table Of Contents
- Table of contents
- Before starting
- Setting Up
- Installation Requirements
- Checking the Accessories
- Unpacking and Installing the Machine
- Installing the Optional Equipment
- Connecting the Power Code
- Connecting a LAN Cable/USB Cable
- Loading Paper in the Tray
- Setting Up This Machine
- Connecting to a Wireless LAN (Only When the Wireless LAN Module is Mounted)
- Installing a Driver and Software to a Computer
- Basic Operations
- Maintenance
- Troubleshooting
- Operating Management/Specifications
- Contact Us
- 89 -
5. Maintenance
13
Close the output tray (a) slowly and push the center of the output tray for
confirmation.
14
Please recycle image drums.
If you must dispose of an image drum, put it in a plastic bag or similar container and dispose of it in accordance
with your municipality's ordinances or guidelines.
This section describes how to replace the image drum and toner cartridge with new ones at
the same time.
• Use extra care when handling the image drum (the green cylinder), because it is fragile.
• Do not expose the image drum to direct sunlight or strong light (approximately 1,500 lux or more). Do not leave the
image drum for 5 minutes or more even under room light.
1
Prepare new image drum and toner cartridge.
2
Press the button (A) and open the output tray (a) completely.
3
Identify an empty toner cartridge by its label color.
4
Remove the image drum (b) from the machine and place it on a flat surface.
Replacing the Image Drum and Toner Cartridge at the Same
Time
Burns may result.
The fuser unit is extremely hot. Do not touch it.