Operation Manual

Maintenance > 138

4. Pull the two fuser retaining levers (2) towards the front of

the printer so that they are fully upright.

5. Holding the fuser by its handle (1), lift the fuser straight

up and out of the MFP. If the fuser is still warm, place it on

a flat surface which will not be damaged by heat.

6. Remove the new fuser from its packaging and remove the

transit material.

7. Holding the new fuser by its handle, make sure that it is

the correct way round. The retaining levers (2) should be

fully upright, and the two locating lugs (3) should be

towards you.

8. Lower the fuser into the MFP, locating the two lugs (3)

into their slots in the metal partition which separates the

fuser area from the image drums.