Operation Manual

Menu functions > 40
System
setup
Near Life
Status
Enable/Disable Set LCD panel control at the time of near-life warning for
drum, fuser and belt.
Enable: Display a near-life warning.
Disable: Do not display a near-life warning.
Near Life
LED
Enable/Disable Controls the settings of the Attention LED when near
end of life warning of toner, drum, fuser, or belt occurs.
Attention LED is lit when enabled, not lit if disabled.
(Displays LCD message.)
The temporary recovery by opening and closing of the
cover in Life error is not included.
Time Setup Date Format mm/dd/yyyy
dd/mm/yyyy
yyyy/mm/dd
Set desired date format.
Time Zone -13:00
~
0:00
~
+13:00
Enter the time zone for your country in relation to GMT.
Set in quarter units within the range.
Use the Menu up/down buttons to increment/decrement
and press the Enter button to set and proceed to the next
digit.
Daylight
Saving
On
Off
Enable/disable daylight saving setting.
Time Setting 01/01/2000
00:00
~
01/01/2009
00:00
~
31/12/2091
23:59
Set current date and time.
Display format follows the settings selected in Date
Format.
Change
Password
New
Password
xxxxxxxxxxxxxx Sets a new password to enter Admin Setup menu
From 6 to 12 alpha/numeric digits can be entered.
Verify
password
xxxxxxxxxxxxxx Forces the User to input the new password to enter Admin
Setup.
From 6 to 12 alpha/numeric digits can be entered.
Settings Reset
Settings
Execute Resets EEPROM of CU. Resets User menu to the factory
default.
If Execute is selected, exits from the menu.
Save
Settings
Execute Saves menus currently set. With this function, the menus
with which operation was last performed are saved, and
overwrites with the menus that were previously saved.
When the Enter button is pressed, the following
confirmation message appears.
Are You Sure? Yes/No
When No is selected, the preceding menus are restored.
When Yes is selected, the current menu settings are
saved and this menu is exited.
ITEM SETTINGS EXPLANATION