Operation Manual

Menu functions > 33
Print Setup
(cont.)
Binding Long Edge
Short Edge
Specifies Binding in duplex printing.
Display Condition: a duplex unit is installed and enabled.
Refer to “Duplex” on page 32.
Media Check Enable
Disable
Sets whether the printer checks the matching of printed
data size and that of the tray. Only standard sizes are
checked.
Resolution 600dpi
600x1200dpi
600dpi multi-
level
Sets default resolution.
Toner Save
Mode
On/Off This function works effectively only if the data input is
color RGB data. This setting is valid in PS and PCL, but
does not take effect in the following cases.
(1) PS: If Color Matching is set OFF.
(2) PS: If any setting other than ASIC Color Matching is
set.
(3) PS: CMYK data when Ink Simulation Mode is used
(valid in any other cases except Case (1) and Case (2)
above as long as data is RGB).
(4) PCL binary data (Color/Monochrome).
Mono-Print
Speed
Auto
Color Speed
Normal Speed
Sets the monochrome print speed. Prints at the most
appropriate speed for page process if Auto is set.
Prints always at the color print speed if Color is set.
Prints always at the monochrome print speed if Normal is
set.
Default
Orientation
Portrait
Landscape
Specifies print orientation.
Not valid for PS (valid only for PCL/ IBMPPR/EPSONFX/
HP-GL2).
Form Length 5 lines
~
64 lines
~
128 lines
Sets the number of lines that can be printed on a page
Not valid for PS (valid only for PCL/HP-GL2).
Default values listed to the left are for Letter/A4. In
practice, however, they change according to the size of
paper loaded in the tray.
Edit Size Cassette Size/
A4/A5/A6/B5/
Legal14/
Legal13.5/
Legal13/Letter/
Executive/
Custom/Com-9
Envelope/Com-
10 Envelope/
Monarch
Envelope/DL
Envelope/C5/
Index Card
Sets the size of an area to draw when the host PC does
not specify the size via the paper edit size designating
command (Not valid for PS - only for PCL).
Trapping Off
Narrow
Wide
Sets trapping.
ITEM SETTINGS EXPLANATION