Operation Manual

Menu functions > 34
Print Setup
(cont.)
X Dimension 64 mm
~
210 mm
~
216 mm
Specifies paper width of Custom paper as a default value.
Sets a paper size at right angles to the paper run
direction.
Y Dimension 127 mm
~
297 mm
~
1321 mm
Specifies paper length of Custom paper as a default value.
Sets a paper size in the same direction as the paper run
direction.
PS Setup Network
Protocol
ASCII/RAW Specifies PS communication protocol mode of data from
NIC port.
(In RAW mode, Ctrl-T is invalid). PS models only.
Parallel
Protocol*
ASCII/RAW Specifies PS communication protocol mode of data from
Centronics port.
(In RAW mode, Ctrl-T is invalid). PS models only.
* This menu item is applicable to the C711 only.
USB
Protocol
ASCII/RAW Specifies PS communication protocol mode of data from
USB port.
(In RAW mode, Ctrl-T is invalid). PS models only.
PCL Setup Font Source Resident Specifies the location of PCL default font.
Font
Number
I0 ~ I90 Sets the PCL font number.
The valid range of this variable changes depending on the
FONT SOURCE setting at the time. If the default font is
set for FONT SOURCE, the number starts at 0. If it is not,
the number starts at 1. The maximum value is equal to
the number of fonts installed in FONT SOURCE.
Font Pitch 0.44 CPI
~
10.00 CPI
~
99.99 CPI
Width of the PCL default font in characters per inch (CPI).
Default font is fixed-pitch, scalable font.
The value of pitch is displayed down to the second
decimal place.
Displayed only when the font selected in Font Number is a
fixed-spacing, scalable font.
Font Height 4.00 point
~
12.00 point
~
999.75 point
Height of the PCL default font. The value is displayed
down to the second decimal place (in 0.25 point
increments).
Displayed only when the font selected in Font Number is a
proportional-spacing, scalable font.
Symbol Set PC-8 Sets the symbol set of PCL (see machine operator panel
for complete list).
ITEM SETTINGS EXPLANATION