Operation Manual

Menu functions > 41
C ALIBRATION
Settings
(cont.)
Restore
Settings
Execute Changes to the menu setting saved.
When the Enter button is pressed, the following
confirmation message appears.
Are You Sure? Yes/No
If No is selected, the previous menu display resumes.
If Yes is selected, changes to the menu settings are
saved and this menu is exited.
Display Condition: The menu settings are saved.
ITEM SETTINGS EXPLANATION
Auto Density
Mode
On/Off Selects whether density adjustment and TRC
compensation is automatically performed.
On: Density adjustment is automatically run under the
engine-specified conditions, and reflected in TRC
compensation.
Off: The printer does not voluntarily run density
adjustment.
Adjust Density Execute If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when the
printer is idling. It can become invalid if executed
in any other state.
Adjust
Registration
Execute When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Print Tuning
Pattern
Execute Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed because TRC is
automatically adjusted to the recommended levels
through density adjustment and TRC compensation.
Adjustment results will be reflected as offset values
(addition) to the corrections through the Adjust
Density/TRC Compensation function.
Cyan/Magenta/
Yellow/Black
Tuning
Highlight -3,-2,-1,
0,+1,+2,+3,
Adjusts HIGHLIGHT (light area) of the TRC.
+ = Darker
- = Lighter
Mid-Tone -3,-2,-1,
0,+1,+2,+3,
Adjusts MID-TONE area of the TRC.
+ = Darker
- = Lighter
Dark -3,-2,-1,
0,+1,+2,+3,
Adjusts DARK area of the TRC.
+ = Darker
- = Lighter
Cyan/Magenta/
Yellow/Black
Darkness
-3,-2,-1,
0,+1,+2,+3,
Adjusts the engine density.
ITEM SETTINGS EXPLANATION