Operation Manual

Menu functions > 45

Storage setup

NOTE

This menu only displays if the optional SD card is installed.

ITEM SETTINGS EXPLANATION

Check File System Execute Resolves mismatch between actual memory and

displayed memory available in a file system. Performs

administration data (FAT information) recovery. Performs

recovery only for an SD Card.

Check All Sectors Execute Performs recovery of defective SD Card sector

information and a file system mismatch mentioned

above.

Enable SD Card No

Yes

Even if a machine is inoperable at installation because of

a faulty SD Card, the machine can be made operable by

setting this parameter to No (ignores the existence of

the SD Card).

When No is set, access to the SD Card results in FAIL

because the SD Card is regarded as not attached.

After setting change and exit from the menu, the printer

will restart.

Erase SD Card Execute Deletion of all data stored in the SD Card. DoD 5220.22-

M sanitizing formula is used for clearing the card. The

machine will restart after changing setup. The following

message appears after pressing the Enter button.

Are You Sure?

Yes

If NO is selected, you will be returned to the source

If Yes is selected the procedure for clearing disk will

start immediately after the machine reboots.

If the Cancel button is held down during erasing, the

following confirmation messages will appear to

discontinue processing.

Do You Wish to Cancel?

Yes

If NO is selected, the procedure will continue. If YES is

selected, the procedure will discontinue.

Enable Initialization No

Yes

Prevents a setting change accompanying initialization of

Block Device (SD Card, FLASH).