Operation Manual

- 35 -
Connecting to a Computer
1
1. Setup
Installing a Printer Driver
(for Windows)
To complete the network connection with a
Windows computer, rst set IP addresses for the
printer, and then install a printer driver on the
computer.
If there is no DHCP server or BOOTP server on
the network, you need to manually congure the
IP address on the computer or printer.
If your network administrator or internet service
provider species an unique IP address for the
computer and your printer, you need to set the
IP addresses manually.
Note
● You need to complete the network setting of the computer
before this procedure.
● To complete this procedure, you must be logged in as an
administrator.
● When setting an IP address manually, ask the network
administrator or your internet service provider which
IP address to use. If the IP address is set wrong, the
network may go down or Internet access may be disabled.
Memo
● If conguring a small network consisting of only your
printer and a computer, set IP addresses as shown below
(according to RFC1918).
For the computer
IP address : 192.168.0.1 - 254
Subnet mask : 255.255.255.0
Default gateway : not used
DNS server : not used
For the printer
IP address Set : Manual
IP address:
192.168.0.1 - 254 (select a
different value from that of the
computer)
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
Network Scale : Small
● To set [Network Scale], press the scroll button
or
and then select [Admin Setup] > [Network Setup] >
[Network Scale].
 First, Set the IP address of the printer.
1 Turn on the printer.
2 Press the <MENU> button on the
operator panel.
3 Press the scroll button to select
[Admin Setup], and press the
<ENTER> button.
4 Enter the administrator password, using
the numeric (0-9) keys.
The factory default password is “999999”. Press
<ENTER> button after each character you input.
5 Press the <ENTER> button.
6 Check that [Network Setup] is selected
and press the <ENTER> button.