Operation Manual

- 89 -
Other Error Messages
3
3. Troubleshooting
Error
code
Message
<ATTENTION>
indicator
Cause/Remedy
Unsupported USB Device Detected
Please detach it
Lights up A USB device unsupported by a printer is
connected. Remove the device.
Install Paper
MPTray
%MEDIA_SIZE%
Press ONLINE Button
Blinks Printing from the MP tray was specied.
Load the paper of the size indicated in the
MP tray, and then press the <ON LINE>
button.
%COLOR% Waste Toner Full.Replace Toner. Lights up Waste toner is full. Replace with a new toner
cartridge of the indicated color.
Collate Fail:Too Many Pages
Press ONLINE Button
Lights up A collate print error has occurred.
Reduce the data amount. If that does not
work, reduce the size of the print data.
File System Operation failed<nnn>
Press ONLINE Button
Lights up An error of le system for a printer has
occurred.
Power Off and Wait for a while
126:Condensing Error
Blinks A condensation has occurred inside a printer.
Turn the printer off and turn on again after
a while.
Invalid Secure Data
Press ONLINE Button
Lights up Invalid source data is received in an
authentication printing and deleted.
USB Hub Unsupported
Please detach it
Lights up A USB hub unsupported by a printer is
connected. Remove the hub.
Log Buffer is Full. Job Rejected
Press ONLINE Button
Lights up Print data is deleted because the accounting
log buffer is full. Contact a printer
administrator and remove the log buffer.
360 Install Duplex Unit
Please see HELP for details
Blinks A duplex unit is not installed correctly.
Install a duplex unit in a printer correctly.
When a duplex unit is already installed, pull
out the unit, and then install it again.
nnn* Service Call
nnn: Error
Blinks An error occurred inside the printer. Turn the
printer off and then on again.
nnn* Power Off/On
nnn:Error
PC:nnnnnnnn
LR:nnnnnnnn
FR:nnnnnnnn
Blinks A fatal error has occurred in a printer.
Write down the indicated alphanumerical
characters and contact your dealer.
709 Caution, unknown Consumable detected
Go to User Manual “Trouble Shooting” to
restore operation
Blinks You can use any consumables in your
product, but you must accept the risks of
using non-genuine consumables. If the use
of non-genuine consumables causes damage
to the product or results in your product
not functioning to its full specication, then
such damage or effect on the product is not
covered by warranty. To accept these risks
and to restore function;
1. Turn off your product
2. Press and hold the CLEAR button and
turn your product on
3.
After start up, release the CLEAR button
Note
This operation will be recorded for future
reference.