Operation Manual

- 55 -
How to Print from the MP Tray
2
2. Printing Basic Operation
ABC
When loading paper vertically or horizontally
Com-10, DL, C5
ABC
C4
Memo
● When loading envelopes in the MP tray, load them face up
with the orientation noted below.
- Com-10, DL and C5 are loaded with the ap folded
and the ap should come to the top side in the feeding
direction.
- C4 is loaded with the ap folded and the ap should
come to the right side in the feeding direction.
Note
● The paper may be wrinkled or curled after printing.
● Use paper stored in proper temperature and humidity
conditions. Do not use paper that is curled or waved
because of humidity.
● Do not print on the back side of paper on which other
printer has printed.
● Curling of a postcard or an envelope may cause the ink
absorbing problem. Use paper that is not curled. Correct a
paper Curling within 2 mm.
● Printing an envelope with an adhesive ap bent cause the
ink absorbing problem.
7 Close the paper set cover (5).
5
If always printing on same size or type paper
from the MP tray, register the paper on the
operator panel. If printing once, proceed to the
step 18.
Note
● When a printer is in the power saving mode, press
the <POWER SAVE> button to restore from the
mode.
● Make sure that the message “Ready To Print” is
displayed in the operator panel. If the message is not
displayed, press the <ON LINE> button.
8 Press the <Fn> key.
9 Enter “90” and press the <ENTER>
button.
10 When [Paper Size] is displayed, select
the size of the loaded paper and then
press the <ENTER> button.
Reference
● If [Custom] is selected for [Paper Size], you need
to register the custom size. For how to register the
custom size, refer to “Printing in Custom Sizes”
P.58.