Operation Manual

Print options – PostScript > 59
Creep Adjustment
Off/Normal/Thick
Creep occurs when booklets
have a large number of pages
or are printed on heavy
media. Use this option to
adjust images that may shift
from the center of the sheet in
booklets.
Select Normal when you use
normal media paper for your
print job.
Select Thick when you use
thick media paper for your
print job.
For more information, see
page 69.
FreeForm: Create Master
None/1-15
To create a FreeForm master
from this job, specify a
number to assign to the
FreeForm master file.
For more information, see
Variable Data Printing manual.
Command WorkStation allows
you to select up to 100
FreeForm Masters. For more
information, see Command
WorkStation Help.
FreeForm: Preview Master
Click to preview
Click to generate a low-
resolution image of the
selected FreeForm Master.
This option is selectable only if
you enable Use Master.
For more information, see
Variable Data Printing manual.
This option is not available for
Mac OS X.
FreeForm: Use Master
None/1-15
For variable data print jobs,
specify the FreeForm master
to use for the job.
For more information, see
Variable Data Printing manual.
Command Workstation allows
you to select up to 100
FreeForm Masters. For more
information, see Command
WorkStation Help.
Image Quality
Normal/Best
Select Normal to provide a
good quality image at high
print speed.
Select Best for higher output
quality. However, selecting
Best may affect the printing
speed.
Image Shift
Off/On
Select On (tick checkbox) to
adjust an image for duplex
(two-sided) printing by
shifting the image
horizontally, in the direction of
paper travel, relative to the
leading edge.
For more information, see
page 69.
Image Shift: Align front and
back images
Off/On
Specify to align the front
cover image to the back cover
image when using the Image
Shift print option.
For more information, see
page 69.
Image Shift: Units
mm/inches/points
Specify the measurement
values when using the Image
Shift print option.
For more information, see
page 69.
OPTION AND SETTINGS
(DEFAULT SETTING IS
EMBOLDENED)
DESCRIPTION REQUIREMENTS,
CONSTRAINTS, AND
INFORMATION