Operation Manual

English
7-24 Chapter 7
9 Are you printing on envelopes, thermal paper, or picture
postcards?
Correct printing and feeding of envelopes and thermal paper cannot be
guaranteed. The back side of picture postcards can be used if the card
is less than 0.23 mm (0.01") thick and manual feed mode is used.
Printing on the photo side is unreliable.
10 Are you using home-made cards or thick cards?
Cards with thickness within the range of 0.07 mm - 0.23 mm (0.003" -
0.01") can be used in manual feed mode.
11 Are there pages piled up near the output slot or in the output paper
tray?
When printed material obstructs the paper output slot, the paper feed
and paper output may not work correctly.
12 Have you loosened the paper sufficiently prior to loading it into the
sheet feeder?
Paper must be riffled several times prior to being loaded into the sheet
feeder. If not, sheets of paper may stick to one another and cause
multiple sheets to feed into the printer at the same time, or other forms
of misfeed.
The printer emits unusual noises when the power is
turned on, and the error lights blink
1 Has the carriage packing material been removed?
Refer to Chapter 1, Introduction for details on removing packing
material.
2 Has the packing tape been removed?
There are two pieces of tape on the front of the printer that help protect
the printer during shipping. Gently remove the tape before using the
printer.
3 Has a cartridge become dislodged from the cartridge holder?
Open the front cover and make sure the cartridges are correctly
installed.
4 Is there a paper jam?
Clear a paper jam by refering to ‘Clearing Paper Jams’ in this Chapter.
Occasionally a small piece of paper will tear off and remain in the