Operation Manual

English
Specialised Printing Operations 5-15
Load the Overhead Transparencies
1
Fan the sheets before loading them into the printer to ensure they do
not stick together.
2
Load the sheets into the auto sheet feeder or manual feed slot in the
correct orientation. The cut corner at the end of the sheet should be
first located into the left side of the printer (when viewed from the
front).
3
To prevent jams remove the sheets immediately after printing.
4
If the last sheet of film will not feed from the auto sheet feeder, place
a sheet of paper underneath it.
Setting up Transparency Separators
Occasionally electrostatic build up may cause a sheet of transparency film
to attach itself to another. To prevent this separator cards must be placed
inside the transparency film box. To set up the transparency separators;
1
Cut along the two inner dotted lines (see Figure 1, number 1) on the
separator card. Discard the middle portion of the card.
2
Fold the two cards along the dotted line (2). The folded angle should
be less than 90 degrees.
3
Take the inner box of the transparency film and insert it into the box
cover (3).
4
Insert the separators into each side of the box between outer cover and
inner box (4). Make sure the folded angle remains at less than 90
degrees.
5
Place the box with the installed separators into the printer paper tray
and align the edge of the box with the centre cover (5) on the printer.
When the transparencies are printing they will ride on top of the
separators, preventing them from picking up any completed transparencies
lying below. When a transparency is completed it will drop through the
separators by the time the next sheet begins printing.