Operation Manual

Appendix A - menu system > 119
Print Setup
(cont.)
Color Menu Density Control Auto, Manual If set to Auto, image
density will be
automatically adjusted
at power on, when a
new image drum or
toner cartridge is
installed, and at
intervals of 100, 300
and 500 drum counts.
If a 500 drum count
interval occurs during
a print job it will occur
at the end of that job,
and will take up to 55
seconds. If set to
manual, this
adjustment will only
be performed when
initiated by the next
menu item.
Adjust Density Execute Selecting this will
perform the auto
density set up
immediately.
Color Tuning/Print Pattern Execute Selecting this item
prints the colour
tuning pattern to help
you adjust the colour
balance.
Cyan Highlight -3 ~ 0 ~ +3 Adjusts image density
for each colour
component (cyan,
magenta, yellow and
black). Normal setting
is 0.
Cyan Mid-Tone -3 ~ 0 ~ +3
Cyan Dark -3 ~ 0 ~ +3
Magenta Highlight -3 ~ 0 ~ +3
Magenta Mid-Tone -3 ~ 0 ~ +3
Magenta Dark -3 ~ 0 ~ +3
Yellow Highlight -3 ~ 0 ~ +3
Yellow Mid-Tone -3 ~ 0 ~ +3
Yellow Dark -3 ~ 0 ~ +3
Black Highlight -3 ~ 0 ~ +3
Black Mid-Tone -3 ~ 0 ~ +3
Black Dark -3 ~ 0 ~ +3
Cyan Darkness -3 ~ 0 ~ +3 Adjusts darkness of
each colour (cyan,
magenta, yellow and
black). Normal setting
is 0.
Magenta Darkness -3 ~ 0 ~ +3
Yellow Darkness -3 ~ 0 ~ +3
Black Darkness -3 ~ 0 ~ +3
ITEM OPTION VALUE/DESCRIPTION