Quick Start Guide

Chapter 6 INFORMATION ABOUT EQUIPMENT
Options
The following options are sold separately, and upgrade the performance of the equipment if installed. For details, contact your
service technician or representative.
68
1. Original Cover (KA-1640PC)
This is used to hold an original.
2. Reversing Automatic Document Feeder
(MR-3025)
This unit automatically feeds a stack of originals one by
one to have them copied.
3. Bridge Unit (KN-2550)
This unit acts as a relay for the Finisher and this equipment .
4. Job Separator (MJ-5006)
Enables Faxes, copies and prints to be output onto
separate paper trays.
5. Paper Feed Pedestal (KD-1032)
This pedestal enables you to install the Additional Drawer
Module.
6. Large Capacity Feeder (KD-1031)
This feeder enables you to feed up to 2000 sheets (80 g/m
2
or 20 lb. Bond) of A4 or LT paper.
7. Additional Drawer Module (MY-1039)
This tray can be added to the Paper Feed Pedestal.
8. Finisher (MJ-1107)
This Finisher enables sort/group nishing and stapling.
The Hole Punch Unit can be installed in this Finisher. The
Bridge Unit is required for the installation of this Finisher.
9. Saddle Stitch Finisher (MJ-1108)
This Finisher enables saddle stitching in addition to sort/
group nishing and stapling. The Hole Punch Unit can be
installed in this Finisher. The Bridge Unit is required for the
installation of this Finisher.
10.
Inner Finisher (MJ-1036)
This Finisher enables sort/group nishing and stapling
The Hole Punch Unit can be installed in this Finisher. This
Finisher can be installed in ES9465 MFP.
11. Hole Punch Unit (MJ-6007)
This unit enables you to punch holes on printed sheets.
Install it in the Inner Finisher to use it.
12. Hole Punch Unit (MJ-6104)
This Unit enables you to punch holes on printed sheets.
Install it in the Finisher or the Saddle Stitch Finisher to use
it.
3 4
10
11
1 2
8 9
12
5 76