LED Printer User Manual
Table Of Contents
- Contents
- Features
- Consumables
- Options
- Operating Your Printer
- Using the Front Operator Panel
- OKIPAGE 10e Front Operator Panel Reference
- OKIPAGE 10e Function Reference
- Changing the Menu Settings
- Using the Printer Menu Setup
- Resetting the Menu
- Using Power Save to Minimize Warm-up Time
- Printing the Menu
- Maintenance Menu
- Using Special Print Media
- Printing a Special Document
- Enhancing Print Quality
- Printing Envelopes
- Selecting Envelopes
- Printing Transparencies and Adhesive Labels
- Guidelines for Transparencies and Labels
- Using Recycled Print Media
- Printer Maintenance
- Replacing The Toner Cartridge
- Replacing the Image Drum Cartridge
- Cleaning the LED Array
- Printing a Cleaning Page
- Problem Solving
- Clearing Paper Jams
- Print Quality Problems
- Software Problems
- Hardware Problems
- Service and Support
- OKIDATA ONLINE
- Your Dealer
- The Okidata Customer Support Center
- Okidata Customer Service Representatives
- Purchasing Supplies
- Warranty Service
- OKIDATA SERVICE CENTERS
- Index
- Index
E-35
Symptom: Cannot get justified right margin with a
proportionally spaced font.
Problem: Right justification with proportional fonts is a
software feature.
Solution: Check your software manual to see if this
feature is supported.
Symptom: Control codes not operating correctly.
Problem: Incorrectly entered control codes.
Solution: Check for confusion of letter l with number 1,
letter O with number 0; make sure you are using
upper/lower case correctly; make sure font is
specified correctly and is available.
Symptom: Data is sent to printer, but nothing happens.
ON-LINE message appears.
Problem: Wrong interface cable.
Solution: Use correct cable. If optional Serial I/F is
installed, make sure RS232C Serial is selected in the
Level 1 menu and RS232C Serial settings in Level 2
menu are correct.
Symptom: Last page of document not printed.
Problem: No form feed provided at end of document.
Solution: Press the ON-LINE button to take the printer
off-line, then press the FORM FEED button to eject
the final page or send the form feed code (decimal
character 12).
Symptom: First line on page won’t print.
Problem: Tops of letters extend into unprintable area,
so none of them print.
Solution: Set your software to print within the printable
area.
Symptom: Parts of control codes are printed at the
beginning of documents.
Problem: Command sent is not a true printer
command, generally because the ESC character was
not sent.
Solution: Before sending control codes through an
application, make sure the ESC character can be
entered, and is entered properly.