LED Printer User Manual
Table Of Contents
- Contents
- Features
- Consumables
- Options
- Operating Your Printer
- Using the Front Operator Panel
- OKIPAGE 10e Front Operator Panel Reference
- OKIPAGE 10e Function Reference
- Changing the Menu Settings
- Using the Printer Menu Setup
- Resetting the Menu
- Using Power Save to Minimize Warm-up Time
- Printing the Menu
- Maintenance Menu
- Using Special Print Media
- Printing a Special Document
- Enhancing Print Quality
- Printing Envelopes
- Selecting Envelopes
- Printing Transparencies and Adhesive Labels
- Guidelines for Transparencies and Labels
- Using Recycled Print Media
- Printer Maintenance
- Replacing The Toner Cartridge
- Replacing the Image Drum Cartridge
- Cleaning the LED Array
- Printing a Cleaning Page
- Problem Solving
- Clearing Paper Jams
- Print Quality Problems
- Software Problems
- Hardware Problems
- Service and Support
- OKIDATA ONLINE
- Your Dealer
- The Okidata Customer Support Center
- Okidata Customer Service Representatives
- Purchasing Supplies
- Warranty Service
- OKIDATA SERVICE CENTERS
- Index
- Index
E-37
Symptom: Strange symbols appear during normal
printing.
Problem: Wrong symbol set.
Solution: Make sure the symbol set selected
corresponds to symbol set resident, in font card, or in
soft font.
Hardware Problems
Symptom: Graphic image prints partly on one page,
partly on the next.
Problem: Insufficient printer memory for this image at
this resolution.
Solution: Change the resolution, reduce the image size,
or install more memory in your printer.
Symptom: Nothing happens, but printer indicates it is
ready to receive data.
Problem: Configuration error.
Solution: Check cable connection; if serial, make sure
appropriate MODE command has been used (PC). If
more than one printer is available, make sure your
printer has been selected. Make sure your printer is
on-line.
Symptom: “Garbage” prints.
Problem: Incorrect cable configuration. (Also, see
“Software Problems.”)
Solution: Check cable configuration, continuity, and
length.
Symptom: Printer freezes or displays error message
when computer is rebooted.
Problem: Booting the computer while the printer is on
can cause a communications error.
Solution: Take printer off-line before rebooting
computer.
Problem: Gases are given off by forms or adhesives
passing through the hot fusing unit.
Solution: Make sure the forms you use can withstand
heating, and provide adequate ventilation.