Copier User Manual
Table Of Contents
- Introduction
- Control Panel and Configuration Menu
- Sending Faxes
- Basic Fax Operation
- Adjusting the Image Quality
- Specifying a Recipient
- Specifying Multiple Recipients
- Sending a Fax at a Specified Time (Timer Transmission)
- Sending a Batch Transmission
- Memory Transmission and Direct Transmission
- Sending a Fax Manually
- Sending a Fax to a Combination of Fax Numbers (Chain Dial)
- Canceling a Queued Transmission
- About the Fax Header
- Faxing From a Computer (PC-FAX)
- Receiving Faxes
- Registering Recipients
- Confirmation Mode
- Troubleshooting
- Appendix
31 Control Panel and Configuration Menu
DEFAULT TX Settings MEMORY TX / DIRECT TX
Select the desired method for sending documents.
MEMORY TX: With this method, the fax trans-
mission starts after the entire document is
scanned and stored in the memory. The total
number of pages is automatically printed with
the page number in the header. However, the
memory may become full if there are many
pages in the document or if the data is large
due to the fine image quality (resolution).
DIRECT TX: With this method, the transmis-
sion is performed in real time in the transmis-
sion sequence of the destinations. If there are
many pages in the document, the fax can be
sent with this method without the memory
becoming full.
To change the method for sending documents during
transmission from the default setting specified here,
refer to “Memory Transmission and Direct
Transmission” on page 54.
Header Settings OFF / ON
Select whether or not to print transmission source
information (date/time of transmission, sender's
name, sender's fax number, session number and
page number) for the machine in the transmitted
document.
" If PTT SETTING in the USER SETTING
menu is set to U.S.A, CANADA and KOREA,
the settings cannot be changed.