Copier User Manual
Table Of Contents
- Introduction
- Control Panel and Configuration Menu
- Sending Faxes
- Basic Fax Operation
- Adjusting the Image Quality
- Specifying a Recipient
- Specifying Multiple Recipients
- Sending a Fax at a Specified Time (Timer Transmission)
- Sending a Batch Transmission
- Memory Transmission and Direct Transmission
- Sending a Fax Manually
- Sending a Fax to a Combination of Fax Numbers (Chain Dial)
- Canceling a Queued Transmission
- About the Fax Header
- Faxing From a Computer (PC-FAX)
- Receiving Faxes
- Registering Recipients
- Confirmation Mode
- Troubleshooting
- Appendix
37 Control Panel and Configuration Menu
Setting Up the Memory RX Mode
1 Press the or key to select UTILITY, and then press the Enter key.
" For details on selecting a menu, refer to “General Procedure for Spec-
ifying Settings in the Utility Menu” on page 36.
2 Press the or key to select FAX RX OPERATION, and then press the
Enter key.
3 Check that MEMORY RX MODE is selected, and then press the Enter key.
4 Using the or keys, select ON, and then press the Enter key.
5 Use the keypad to type in the time when memory reception mode begins, and
then press the Enter key.
The ending time input box appears.
" To specify no start time, press the key without specifying a time.The pass-
word input box appears. Continue with step 7.
6 Use the keypad to type in the time when memory reception mode ends, and
then press the Enter key.
The password input box appears.
7 Enter the password, and then press the Enter key.
Memory reception mode is set.
" The password is required for turning off memory reception mode or
changing the start/end times. Enter a 4-digit number.
" To specify no password, press the Enter key without specifying a pass-
word.